fedora 11 and panda3d

madbad · November 15, 2009, 2:13pm

scuac:

hi, I just tried creating the RPM for Fedora 11 (downloaded the source from here). I tried the command above, and everything seems to have compiled correctly (except for some warnings saying that _XOPEN_SOURCE was redefined). But when it gets to the part where it is building the RPM it fails with the following error list:
RPM build errors:
    File not found: /home/scuac/rpmbuild/BUILDROOT/panda3d-1.6.2-1.x86_64/etc/Confauto.prc
    File not found: /home/scuac/rpmbuild/BUILDROOT/panda3d-1.6.2-1.x86_64/etc/Config.prc
    File not found: /home/scuac/rpmbuild/BUILDROOT/panda3d-1.6.2-1.x86_64/usr/share/panda3d
    File not found: /home/scuac/rpmbuild/BUILDROOT/panda3d-1.6.2-1.x86_64/etc/ld.so.conf.d/panda3d.conf
    File not found: /home/scuac/rpmbuild/BUILDROOT/panda3d-1.6.2-1.x86_64/usr/bin
    File not found: /home/scuac/rpmbuild/BUILDROOT/panda3d-1.6.2-1.x86_64/usr/lib
    File not found: /home/scuac/rpmbuild/BUILDROOT/panda3d-1.6.2-1.x86_64/usr/include/panda3d
I checked and /home/scuac/rpmbuild/BUILDROOT is empty. Should I put those files there myself from somewhere else?

Thanks

Same problem here under Ferdora 11 64bit

I’ve also tried to run the samples before installing as suggested into the readme (adding the foldet inyo my path) but with no luck

[madbad@localhost Fireflies]$ echo $PATH
/usr/lib64/qt-3.3/bin:/usr/kerberos/bin:/usr/lib64/ccache:/usr/local/bin:/usr/bin:/bin:/usr/local/sbin:/usr/sbin:/sbin:/home/madbad/bin:/home/madbad/bin:/home/madbad/Scrivania/panda3d-1.6.2/built/bin:/home/madbad/Scrivania/panda3d-1.6.2/built/bin:/home/madbad/Scrivania/panda3d-1.6.2/built:/home/madbad/Scrivania/panda3d-1.6.2


[madbad@localhost Fireflies]$ python ./Tut-Fireflies.py
Traceback (most recent call last):
  File "./Tut-Fireflies.py", line 6, in <module>
    import direct.directbase.DirectStart
ImportError: No module named direct.directbase.DirectStart
[madbad@localhost Fireflies]$