Performance Issue: Excessive Fill

Don't mind the mess!

We're currently in the process of migrating the Panda3D Manual to a new service. This is a temporary layout in the meantime.

Transparency

In general, it is better for your graphics card to render the polygons front-to-back, because a depth test can be used to toss out the occluded fragments before they are written to the framebuffer.

When enabling the M_alpha or M_dual transparency modes, however, Panda forces the nodes with this transparency mode to be sorted back-to-front. This is necessary for alpha blending to work correctly. If you have many occluded polygons in view, for example thousands of blades of grass that are positioned behind each other, this may quickly consume your fill rate.

Do not enable transparency modes unless it is necessary, and when you do, consider using the M_binary mode, which does not require back-to-front sorting. However, if alpha blending is required and if large areas of the polygons are fully transparent, using M_dual may provide an improvement over M_alpha.

For a more in-depth explanation on the various transparency modes, see Transparency and Blending.

Incomplete Section

Note: this section is incomplete. It will be updated soon.

Previous Top Next